Radon Mitigation Systems Mn
Radon Mitigation Systems Mn
Installing a Radon mitigation system in MN, Minnesota, should be the very next thing you do after conducting a Radon test using one of the radon test kits. If it has been ascertained that your home’s radon levels are above the recommended levels(4pCi/L) then you need not waste any further time in installing proper Radon mitigation set up.
EPA Recommended Radon Mitigation systems
The EPA and the Minnesota Department of Health have recommended that radon levels exceeding 4pCi/L, in any building, either residential or commercial building must be mitigated using a proper Radon mitigation system. This also has to be done by a certified radon mitigation specialist. Be sure to contact us for installing your radon system today.
Don’t Hesitate To Call Us For Your Mitigation System ⇒
so, you want to install a Radon mitigation system what are the best system available to you?
Type of Radon Mitigation Systems
Here are some of the best radon mitigation systems that can be installed in any building be it residential or commercial.
The different types of Radon mitigation systems can be grouped generally into four; the active soil depressurization, the passive soil depressurization, the crawlspace submarine depressurization system, and the sump pit system.
The active soil depressurization system can further be grouped into three subcategories namely the interior, exterior, and concrete slab methods.
The Active Soil Depressurization Radon System:
This system is usually installed in older homes, i.e homes built in and around the 20th century. It involves actively forcing the soil to emit the radon gases that have been compressed in it through a depressurization technique. Some of these techniques include the following;
The Interior Soil Depressurization System:
This method of Radon mitigation involves creating pressure in the radon-laden soil.
This is by far the most preferred radon mitigation system. The reason is not far fetched. Since most systems of mitigating radon involve installing pipes outside one’s home, many homeowners do prefer to have the pipes installed inside, to keep their home’s exterior neat.
Here is how this system is installed:
- Pipes are installed either in your basement or garage.
- A Radon fan will then be installed in your attic, the pipes and fan will be connected together. The fan is similar to a plumbing stack, so should sit just fine on your rooftop.
- A system monitor will be put in place near the vent line in your basement or garage. This allows you to effectively monitor the system to ensure that it functions properly.
- The radon gas will flow through the pipes and be expelled through the fans
- This is a neat and clean system when installed by a Radon specialist in Minnesota, as this will ensure the safety and well-being of you, your family, and your clients(If you’re an agent)
The Exterior Soil Depressurization System:
Yet another active soil depressurization system where pressure is applied to the soil to suck out any Radon gas in it.
Very similar to the Interior soil depressurization system, but differs as the Pipes are installed outside the home. This ensures you do not have to worry about having radon gas running through a pipe in your house. Here’s how it is done:
- Pipes are installed on the walls of your home.
- A Radon fan will be installed at ground level so it can push the radon gas from your foundation to your rooftop through the pipes.
- The pipes and fan will be connected together like in the interior system.
Many do prefer this system because it means they don’t have to deal with pipes inside their homes while others are not so fond as it does not make for great aesthetics. Whichever method you choose what matters is that it’s done properly by an expert Radon specialist.
The Concrete Slab Soil Depressurization:
The last of the active Radon system available to you. This system is done if your home is under a concrete slab foundation.
- A hole of about five or six inches will be drilled in your concrete slab foundation.
- After this comes the installation of a PVC pipe, with one end inserted into the drilled hole. You may choose to have the pipe installed anywhere in your home.
- The PVC pipe will be routed to your home’s roofline, it is from this route any radon gas present in your home will be removed.
This is the best method of radon mitigation if your home is on a concrete foundation.
The Passive Radon Mitigation System
This is one of the best Radon mitigation system MN. Unlike the active soil depressurization method where the Radon gas is forced from the soil, this system involves a more laid-back and calculated approach.
Radon gas entry points like holes, gaps cracks, and openings in your home are first sealed. A mitigating system is then installed, the function of the system is to trap and remove any gas that makes its way from these holes. This system usually does not require a radon fan, however, for accuracy and effectiveness, it is best you install a fan alongside.
Homes built in Minnesota after 2011, are required to have a passive Radon mitigation system installed.
The CrawlSpace Sub-Membrane Depressurization System:
This system of radon mitigation is installed in homes with crawl spaces or exposed dirt as part of its foundation. This how it is installed in Minneapolis homes.
- A high-density polyethylene vapor barrier is laid on the soil
- Then seams are sealed, and the edges are sealed to the foundation walls
- Landscaping pipes are installed beneath the polythene
- PVC pipes are then connected to serve as a pathway for the gas to escape.
- A functional Radon fan is then inserted to help flush out the radon gas.
- After this, your home’s radon levels will be reduced, making it safer for your household and also reducing your risk of getting lung cancer.
The Sump Pit Radon Mitigation Systems:
This system utilizes existing rainwater drainage systems to mitigate radon gas levels any building.
The steps for installing this radon mitigation system in Minnesota, is as follows:
- Creating and installing an airtight lid for the sump pit.
- Creating a penetration in the lid for the radon pipe and possibly the pump water discharge pipe.
- A PVC pipe pathway will be connected to remove the soil gasses and reduce the sub-slab pressure.
- A Radon fan will be installed.
- An exhaust pipe is connected to the roof-line;
- The Radon gas flows to the exterior of the home.
- Your home is freed and mitigated from Radon.
You should note that each home in Minnesota and Minnesota differs from one another, as such, the radon mitigation system to be used will also differ. The system used in your previous home can differ from the ones used in your new home and so will the cost differ. Also it is not uncommon to have more than one Radon mitigation systems being installed in a home this is usually due to the size, location and level of Radon concentrated in the particular building.
To fully understand this, it is paramount to conduct a Radon test and contact a radon specialist in Minneapolis MN today.
Call To Mitigate Radon Now & Get A Free Quote Today
Radon Mitigation System Cost
The cost of each radon mitigation system differs from one another. Factors such as the type of house, the size, type of foundation, and location of a home play a big factor in determining such. Furthermore, each mitigation system is to be custom-built for you. Help us answer a few questions and receive a free quote from us
The average price for radon mitigation is $1200 nationally. However, the price falls between $800 to $3000, depending on the level of work that needs to be done. Our prices are set with Minneapolis citizens in mind, you can be sure to get a fair quote from us without compromising on quality. Give us a call today
Questions About Radon Mitigation Systems In Minnesota
Can I Install My own Radon Mitigation System?
You can install your own radon mitigation system. There are DIY radon materials out there which cost around $400 – $600. However, it is recommended you call a radon expert to remove radon in your home. As radon is a delicate topic that requires specialist hands.
Do radon mitigation systems really work?
Yes, radon mitigation systems really do work. The right system for the right house has to be done though and by expert radon contractors. To know if your mitigation system really worked, just conduct tests regularly.
When should you install a Radon mitigation system
The EPA and the Minnesota department of health recommends that you install a Radon mitigation system when your levels exceed 4pCi/L. This level of Radon gas is regarded as dangerous.
What Should I Look For In A Properly Installed Radon Mitigation System?
What you should look for in a radon mitigation system is first that all radon fans are properly installed outside the living area of your home. This allows the mitigation system to start pulling the thousands of pCi/L of radon out of the ground and blow it into the basement or crawlspace then discharge it above the roof.
Who Should I Get To Install A Radon Mitigation System In Minnesota?
An expert in radon mitigation systems is what you need. Here at Minnesota Radon Pros™, we cover the whole of Minnesota in radon reduction, removal, and mitigation systems. Don’t contact a non-expert and get ripped off. Be in touch today. Or Call (612) 428-4702
How Much Does it Cost to Put In Radon Mitigation?
The cost of radon mitigation can be anywhere from $700 to $2000. This depends on the size of the home, the type of house, and the level of radon in the house. 70% of Minnesota Radon mitigation systems can be installed for around $1000.
Here are the areas in Minnesota we serve. Give us a call today if you’re in these areas. 612 – 428-4702
- Apple Valley Radon Testing / Radon Mitigation
- Alexandria Radon Testing / Radon Mitigation
- Bloomington Radon Testing / Radon Mitigation
- Brooklyn Radon Testing / Radon Mitigation
- Burnsville Radon Testing / Radon Mitigation
- Chaska Radon Testing / Radon Mitigation
- Coon Rapids Radon Testing / Radon Mitigation
- Cottage Grove Radon Testing / Radon Mitigation
- Eagan Radon Testing / Radon Mitigation
- Eden Prairie Radon Testing / Radon Mitigation
- Farmington Radon Testing / Radon Mitigation
- Hastings Radon Testing / Radon Mitigation
- Lakeville Radon Testing / Radon Mitigation
- Lake Elmo Radon Testing / Radon Mitigation
- Mendota Heights Radon Testing / Radon Mitigation
- Maple Grove Radon Testing / Radon Mitigation
- Plymouth Radon Testing / Radon Mitigation
- Rochester Radon Testing / Radon Mitigation
- Rockford Radon Testing / Radon Mitigation
- St. Paul Radon Testing / Radon Mitigation
- St. Michael Radon Testing / Radon Mitigation
- Waconia Radon Testing / Radon Mitigation
- White Bear Lake Radon Testing / Radon Mitigation
- Wyoming Radon Testing / Radon Mitigation
Trusted for Radon Mitigation Systems by
Useful Radon resources
Want to know more about radon, give us a call for a free radon quote/education today. 612 – 428-4702
You can also find useful information about radon in Minnesota, using these useful radon gas resources.